Perfect International Instruments Co., Ltd
Perfect International Instruments Co., Ltd Not Guess , But Test !
Add to Cart
Bags Vibration Abrasion Durability Testing Machine For Luggage Trolley Wheel
Bags Vibration Abrasion Durability Testing Machine For Luggage Trolley Wheel
Use Description
Testing Machine For Luggage Trolley Wheel use to test any luggage, baggage, suitcase or stroller, trolley which attach with road wheel, to test the material, abrasion and damage deformation of wheel, and the test results can be a reference to improve road wheel.The tester is simulating walking of luggage subject to abrasion and vibration from ground, check quality of travelling wheel, axle, wheel stand, draw bar and the main box.The testing result can be preference to improve the products.The luggage is carried specific load.Start the wheel roller walking tester. The roller will rotate, and conflict and impact with travelling wheel of luggage, create shock vibration and abrasion.
Bags Vibration Abrasion Testing Machine Specifications :
| Model Number | PT-9022 |
| Test Speed | 0 ~ 5 km/hour adjustable |
| Time Setting | 0~999.9 hours, power failure memory type |
| Bump Board | 8 pieces |
| Length of Belt | 380 cm |
| Width of Belt | 76 cm |
| Auxiliary Accessory | Fixed adjust seat |
| Dimensions | 220 X 180 X 160 cm (W X D X H) |
| Weight | About 360 kg |
| Power | 1Ø, AC 220V, 50~60HZ, 8A |
Basic load: the basic load in the luggage is according to the following table , (unit : kg )
Testing Steps For Bags Vibration Abrasion Durability Testing Machine :
1.As stipulated in the table will tie all pull out, and the pull rod connected to the enclosure, inclusion of expansion joints in the other 8 kg load, loading the rod to hang on the supporting frame, adjust the tie rod and the level Angle to 45 ° plus or minus 2 °;No load is required for bags with trolley without pull rod.
2. Adjusted speed: the test requires 4km/hour.Adjust the upper right knob of the panel to reduce the left rotation speed and increase the speed range to 0 ~ 5 km/h.
20% (1.5km /h), 50% (2.5km/h) and 100% (5km/h).
Requirements for the wear-resistant and shock-resistant performance of the walking wheel pull rod: the test was conducted under the specified loading conditions, and the qualified products were tested continuously for 8km, while the excellent products were tested for 12 km.
3. Set time: 0 ~ 999.9 hours.Press [RST] to return to zero at any time and press [START] to retime.
Setting of timer: press "set" to enter the preset value change state, and the number flicker is the value to be changed. "low" and "low" are the increase and increase of the number
Delta theta is the displacement key.After setting, press MD key to exit the setting screen.
4. Retest: when retest, press the timer RST key to return to zero before starting again.
5. Test process: pay attention to whether the wheel is damaged or the belt will be damaged.
6. Test results: after the test, the running wheel has flexible rotation, no resistance and deformation;No deformation cracking of wheel frame and axle;Wheel wear is not greater
2 ㎜.Inspect trunk and wheels for damage and record.
Luggage Walk Test machine Picture :